Bill Taylor's Journal
Home Page: Bill Taylor
Seattle, WA, USA
| Total Posts: 3 | Latest Post: 2006-05-11 |
| Table of Contents | RSS Feed |
Not at the pace of others, but I am almost there. Here are two shots of the engine bay. Second shows the car number (26098) stamped in front of radiator support on passenger side. Worker could have used a larger hammer?
engine bay
Car number 26098
Here are three shots of underside after stripping, etc.
Prep Step and Zero Rust
Another shot
imgp0816.jpg
imgp0817.jpg
imgp0818.jpg
Member Comments on Journal Entry: Uderside Ready For Next Step. ↵
2005-09-14 21:02:13 # 34
Comment by John Moore
wow! That looks extremely clean. Did you sand blast or use another method to strip. Looks incredible.
2005-09-15 12:11:32 # 35
Comment by Bill Taylor
John: I used heat gun for undercoating, then paint stripper, follwed by wirre wheel on 1/4" drill, and small wire brush. Treated with ZeroRust Prep Step to inhibit flash rust. Looks like I can't stall any longer and will order epoxy primer and start spraying. Next Journal entry will be the sills and that one third floor pan missing in lower portion of third pic.
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free
Finally got the wheels cleaned up and painted with Omni AE, code Ditzler DAR2593. Will have tires mounted next week. Added picture of wheel with tire mounted and hub cap attached.
Finished product
Down to bare metal.
Zero Rust primer.
Silver in Omni AE w/o hardener.
X 4
Member Comments on Journal Entry: Wheels ↵
No comments have been posted yet...
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free
Want to leave a comment or ask the owner a question?
Sign in or register a new account — it's free